The SE method requires you to find the command from a set of cascading drop-downs, then find the area of the ribbon where you want to put it, and then use the Add> Customize interface) gives you a block of icons, SE gives you a linear list (cascading drop-downs). I like to select an icon from a list, then drag and drop it where I want it. The one thing I will say right off the bat is that I like the SolidWorks way of adding items to toolbars better than Solid Edge’s. When you consider that Synchronous Technology has a big impact on sketching, the conceptual differences become even larger. The differences between them are much more structural. In the end, that similarity probably means that they share the strengths and weaknesses of Dcubed, but the comparison can’t be limited to that. You might think Solid Edge and SolidWorks sketchers are pretty similar because they both use the (Siemens) Dcubed constraint solver. In this case I’m going to look at sketching, arguably the single most important function of any CAD program. That’s why when I have taken the topic up on the Dezignstuff blog, I would bite off “small” areas like surfacing, sheet metal, or the overall interface. There’s nothing meaningful I could do to compare the entire Solid Edge and SolidWorks programs in a single blog post.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |